Alliance Laundry Systems 100, 135, 165, 18, 200, 33, 35, 40, 55, 75 Operator Safety

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Safety Information

5

9001000

Operator Safety

To ensure the safety of machine operators, the

following maintenance checks must be performed

daily:

1. Prior to operating the machine, verify that all

warning signs are present and legible. Missing or

illegible signs must be replaced immediately.

Make certain that spares are available.

2. Check door interlock before starting operation of

the machine:

a. Attempt to start the machine with the door

open. The machine should not start with the

door open.

b. Close the door without locking it and attempt

to start the machine. The machine should not

start with the door unlocked.

c. Close and lock the door and start a cycle.

Attempt to open the door while the cycle is in

progress. The door should not open.

If the door lock and interlock are not functioning

properly, call a service technician.

3. Do not attempt to operate the machine if any of

the following conditions are present:

a. The door does not remain securely locked

during the entire cycle.

b. Excessively high water level is evident.

c. Machine is not connected to a properly

grounded circuit.

Do not bypass any safety devices in the machine.

NEVER insert hands or objects into

basket until it has completely stopped.

Doing so could result in serious injury.

SW012

WARNING

Never operate the machine with a

bypassed or disconnected balance

system. Operating the machine with

severe out-of-balance loads could result

in personal injury and serious equipment

damage. SW039

WARNING

Contents

Main Installation Washer-Extractors Cabinet Freestanding Refer to Page 6 for Model Identification Keep These Instructions for Future Reference. Page Table of Contents Safety Information Explanation of Safety Messages Important Safety Instructions DANGER Page Safety Decals Operator Safety Introduction Model Identification Information in this manual is applicable to these models: Page Nameplate Location Replacement Parts Customer Service * Specifications and Dimensions Page Page Page 14 Figure 3 15 Figure 4 16 Figure 5 17 Figure 6 18 Figure 7 19 Figure 8 20 Figure 9 21 Figure 10 22 Figure 11 23 Figure 12 24 Figure 13 Installation Dimensional Clearances Table 1 Tabl e 1 shows recommended minimum clearances on all sides of the washer-extractor. Recommended Minimum Clearances Model 18253335405575100135165200 Machine Foundation 27 Mechanical Installation 18 MODEL Figure 14 28 Figure 15 25 POUND 29 Figure 16 33 MODEL 30 Figure 17 35 MODEL 31 Figure 18 40 MODEL 32 Figure 19 55 MODEL 33 Figure 20 75 MODEL 34 Figure 21 100 MODEL 35 Figure 22 135 MODEL 36 Figure 23 165 POUND 37 Figure 24 200 POUND 38 18, 25 and 35 Pound Capacity with A or M in the 8th position of the Model Number (e.g. *X18PVXA6) 18 MODEL Figure 25 39 Figure 26 25 MODEL 40 Figure 27 35 MODEL Mounting Bolt Installation (If Required) Removing the Transport Brackets 43 Figure 30 Figure 32 Figure 31 Drain Connection Page Water Connection Electrical Installation DANGER Page Page Electrical Connection Remote Liquid Supply Connection Chemical Injection Supply System Steam Requirements (Steam Heat Option Only) Supply Programming Table NOTE: The Supply button is button 6. Supply Relay Configuration (No Wiring) Primary 220 Volt Remote Liquid Supply Connection Primary 220 Volt Remote Liquid Supply Connection (Continued) Out-of-Balance Switch Automatic Lubricator Control Function Test (L1) (L2) (L3) MACHINE