Manuals / Brands / Laundry Appliance / Washer / Alliance Laundry Systems / Laundry Appliance / Washer

Alliance Laundry Systems Out-of-Balance Switch, Automatic Lubricator

Models: 100 135 165 18 200 33 35 40 55 75

1 57

Download 57 pages, 1.56 Mb

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Installation

9001000

54

Out-of-Balance Switch

Figure 40

The out-of-balance switch is mounted on the upper

right side on the back of the control panel. There is a

window around the probe of the switch that is mounted

on the movable part of the machine.

When the machine goes out of balance by overloading

or uneven distribution of the linen, the out-of-balance

switch will interrupt this action to prevent damage to

the machine.

IMPORTANT: To guarantee good functioning, the

probe should be centered horizontally and

vertically at 1/3 from the bottom of the tilt window

(when machine drum is empty).

Automatic Lubricator

Only for 75-200 Models

Figure 41

The bearing house of the machine is equipped with a

lubricating device (1) which automatically lubricates

the bearing during one year. Upon delivery of the

machine, this lubricator has been brought into use.

When replacing, please put on the matching screw (2)

in the foreseen opening of the lubricator to activate.

Refer to the machine’s Parts Manual for lubricating

device parts in formation.

CFS501N

1Window

2Probe

1

2

CFS502N

1Lubricating Device

2Screw

12

Ignoring this instruction will inevitably

cause damage to the bearings and void

the warranty! W492

WARNING

Contents

Main Installation Washer-Extractors Cabinet Freestanding Refer to Page 6 for Model Identification Keep These Instructions for Future Reference. Page Table of Contents Safety Information Explanation of Safety Messages Important Safety Instructions DANGER Page Safety Decals Operator Safety Introduction Model Identification Information in this manual is applicable to these models: Page Nameplate Location Replacement Parts Customer Service * Specifications and Dimensions Page Page Page 14 Figure 3 15 Figure 4 16 Figure 5 17 Figure 6 18 Figure 7 19 Figure 8 20 Figure 9 21 Figure 10 22 Figure 11 23 Figure 12 24 Figure 13 Installation Dimensional Clearances Table 1 Tabl e 1 shows recommended minimum clearances on all sides of the washer-extractor. Recommended Minimum Clearances Model 18253335405575100135165200 Machine Foundation 27 Mechanical Installation 18 MODEL Figure 14 28 Figure 15 25 POUND 29 Figure 16 33 MODEL 30 Figure 17 35 MODEL 31 Figure 18 40 MODEL 32 Figure 19 55 MODEL 33 Figure 20 75 MODEL 34 Figure 21 100 MODEL 35 Figure 22 135 MODEL 36 Figure 23 165 POUND 37 Figure 24 200 POUND 38 18, 25 and 35 Pound Capacity with A or M in the 8th position of the Model Number (e.g. *X18PVXA6) 18 MODEL Figure 25 39 Figure 26 25 MODEL 40 Figure 27 35 MODEL Mounting Bolt Installation (If Required) Removing the Transport Brackets 43 Figure 30 Figure 32 Figure 31 Drain Connection Page Water Connection Electrical Installation DANGER Page Page Electrical Connection Remote Liquid Supply Connection Chemical Injection Supply System Steam Requirements (Steam Heat Option Only) Supply Programming Table NOTE: The Supply button is button 6. Supply Relay Configuration (No Wiring) Primary 220 Volt Remote Liquid Supply Connection Primary 220 Volt Remote Liquid Supply Connection (Continued) Out-of-Balance Switch Automatic Lubricator Control Function Test (L1) (L2) (L3) MACHINE