Alliance Laundry Systems H2641 12

Installation

Meter Case

The factory mounted coin meter case does not include the service door lock, slide, coin drawer, coin drawer lock or keys. These parts must be ordered (at extra cost) according to the purchaser’s requirements, direct from the manufacturer of your choice.

NOTE: You have the option of using a screw type lock or a 1/4 turn lock on the meter case service door. If you choose to use a screw lock, then the special bracket (located inside the meter case) must be used. DO NOT use the special bracket if a

1/4 turn lock is used.

Coin Drawer Security – For additional security, drill out the two pilot holes on each front side of the meter case to 1/4 turn or 5/16 inch (6.4 or 7.9 mm) holes, and install a bicycle lock through these holes.

Before You Start

Tools

For most installations, the basic tools you will need are:

1	2	3

D820I

1Wrench

2Screwdriver

3Pliers

4Socket Wrench

5Level

Figure 1

Electrical

Refer to serial plate for specific electrical requirements. For more detailed information, refer to section on Electrical Requirements.

Water

Washer needs two standard 3/4 inch (19.1 mm) water supply faucets with a pressure between 20 and

120 pounds per square inch (138 to 827 kPa). For more detailed information refer to section on Water Supply Requirements.

800536