Installing the Washer

Step 1: Position Washer Near Installation Area

Move washer so that it is within four feet of the desired area of installation.

H135I

H135I

Figure 2

Step 2: Connect Water Inlet Hoses

NOTE: Refer to section on Water Supply Requirements before connecting water inlet hoses.

Remove the four plain rubber washers from accessories bag, and install them according to Figure 3.

Turn on the water supply faucets and flush the lines for approximately two minutes to remove any foreign materials that could clog the screens in the water mixing valve.

NOTE: When installing in newly constructed or renovated building, it is very important to flush the lines since build-up may have occurred during construction.

Installation

IMPORTANT: Thread hose couplings onto valve connections finger-tight, then approximately 1/4 turn with pliers. DO NOT cross thread or overtighten couplings.

Turn water on and check for leaks. If leaks are found, retighten the hose couplings. Continue tightening and rechecking until no leaks are found.

1 1

2

H091I

1Rubber Washer (Plain)

2Inlet Hose

Figure 3

23

1

 

WATER

4

MIXING

VALVE

H137I

H137I

1Water Supply Faucets

2Hot Water Connection

3Cold Water Connection

4Water Inlet Hoses

Figure 4

800536

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

11