Before You Start
Tools
For most installations, the basic tools you will need are:
12
3
4
D074I
D074I
1Wrench
2Screwdriver
3Pliers
4Level
Figure 2
Electrical
Washer needs a 120 Volt, 60 Hertz, polarized three slot effectively grounded receptacle. For more detailed information, refer to section on Electrical
Requirements.
Water
Washer needs two standard 3/4 inch (19.05 mm) water supply faucets with a pressure between 20 and 120 pounds per square inch. For more detailed information refer to section on Water Supply Requirements.
Installation
Installing the Washer
NOTE: If the washer is delivered on a cold day (below freezing), or is stored in an unheated room or area during the cold months, do not attempt to operate it until the washer has had a chance to warm up.
Step 1: Remove the Shipping Brace and Shipping Plug
IMPORTANT: Install dryer before washer. This allows room for attaching exhaust duct.
Remove the shipping brace from under the lid. The plastic shipping plug will be released from the base of the washer when removing the cardboard base from the washer.
The shipping brace and plug should be saved and must be reinstalled whenever washer is moved or transported to a new location. This will prevent damage to washer components.
Do not tilt washer to front or sides when moving.
Refer to
1
2
TLW520N
1Shipping Brace
2Shipping Plug
Figure 3
38857 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 9 |