Alliance Laundry Systems W446I Step 8: Check Lid Switch, Step 6: Plug In the Washer, Step 9: Check Installation, Step 7: Add Water to the Washer

Step 6: Plug In the Washer

Refer to the following section on Electrical Requirements before plugging in the washer.

D254I

Figure 10

Step 7: Add Water to the Washer

To prevent damage to pump, do not run washer before adding at least one quart water to the tub. If the washer is run before any water is added, the pump seal may overheat, causing the pump to leak. Once installed, the water retained in the drain system from the previous cycle will provide sufficient cooling to prevent pump seal damage.

NOTE: The agitator should not be removed except for service. The washtub is designed to be self- cleaning.

TLW524N

Figure 11

Installation

Step 8: Check Lid Switch

Washer should stop filling, agitating and spinning when lid is opened.

TLW1974N

Figure 12

Step 9: Check Installation

Refer to Installer Checklist on the back cover of this manual and make sure that washer is installed correctly.

38857