Maintenance
Variable Water Level Control
The washer is equipped with a variable water level pressure switch (located inside the control hood) which allows the owner to adjust the water fill level height in the washtub from 10, 11 or 13 inches.
IMPORTANT: If the 10 inch water conservation setting is selected, washing performance and machine reliability may be reduced.
When the washer leaves the factory, the pressure switch is set for approximately 11 inches of water.
To adjust the pressure switch, proceed as follows:
WARNING
To reduce the risk of electric shock, disconnect the electrical power to the washer before attempting to service.
W094
1.Remove the two control panel attaching screws and lift the assembly up and out of the slots in the cabinet top.
2.Lay the control panel face down (on protective padding) on top of the washer.
3.Rotate the cam on the pressure switch clockwise to lower the water fill height, or counterclockwise to raise the height. Refer to
IMPORTANT: The cam has three settings. The setting on the left raises water level to 10 inches. Middle setting raises water level to 11 inches. The setting on the right raises water level to 13 inches.
4.Carefully reinstall the control panel.
5.Reconnect the electrical power to the washer.
6.Run the washer through a cycle and observe the water fill level.
WARNING
Any disassembly requiring the use of tools must be performed by a suitably qualified service person.
W299
1
2
4
W157I
3
W157I
1Cabinet Top
2Rotating Cam
3Pressure Switch
4Pressure Hose
Figure 48
32 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 38857 |