Additional Washer Security
(Coin Models Only)
WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the washer before servicing.
•Never start the washer with any guards/ panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the washer is properly grounded.
W003
Located on the service door of the washer is a flat Phillips head screw. During shipment, this screw is used to attach the service door to the meter case. For additional security, this screw can be reinstalled inside the control hood of your washer.
The following list is the procedure required to install the Phillips head screw and
1.Remove the Phillips head screw from service door (refer to Figure 18).
2.Remove two screws holding control panel to control hood.
3.Tilt control panel forward and lay on a protective pad to prevent scratching of cabinet top.
4.Insert Phillips head screw down through double “D” hole in left rear corner of cabinet top (inside control hood) until it engages retainer nut located on left rear corner gusset of cabinet.
5.Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten screw. Torque of a power driver could
WARNING
Any disassembly requiring the use of tools must be performed by a suitably qualified service person.
W299
NOTE:
Installation
Enclosed in the shipping bag are four
6.Secure control panel to control hood using two No. 8
7.Remove two screws holding front panel to base of washer and install two No. 12
2
1
W276I
3
W276I
135528 No. 8 Screws
2Double “D” Hole
335227 No. 12 Screws
Figure 18
Bit (No. 8 screws) Part No. 281P4 Bit (No. 12 screws) Part No. 282P4 Bit Holder (3/8 drive) Part No. 24161
Control panel
38857 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 19 |