Refer to section on Drain Facilities before connecting drain hose to drain receptacle.
Installation
High Standpipe Installation
NOTE: No. 562P3 Siphon Break Kit and No. 25863 Hose Coupling are not required for this type of installation.
Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp.
Follow the instructions for your type of drain receptacle (high standpipe or low standpipe) to properly install the drain hose.
IMPORTANT: Drain receptacle must be capable of handling a minimum of
1
RECOMMENDED
STANDPIPE
1
MAXIMUM
STANDPIPE
HEIGHT NOT TO EXCEED 5 feet (1.5 m)
2
{
3
W296I
HEIGHT
36inches
MINIMUM
(92 cm)
2
W294I
1Drain Hose
2Standpipe
Figure 6
1Drain Hose
2Cut Drain Hose off at This End to Fit the Washer Installation
3Standpipe
Figure 7
38857 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 11 |