Installation
Water Supply Requirements
WARNING
Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used for such a period and before using the washer, turn on all hot water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. THE GAS IS FLAMMABLE, DO NOT SMOKE OR USE AN OPEN FLAME DURING THIS TIME.
W029
Water supply faucets must fit standard 3/4 inch (19.1 mm) female garden hose couplings. DO NOT USE
NOTE: Water supply faucets should be readily accessible to permit turning them off when washer is not being used.
Water Temperature
Cold:
Recommended cold water temperature is 50° to 75° Fahrenheit, 10° to 24° Celsius.
Hot:
Recommended hot water temperature is 140° to 150° Fahrenheit, 60° to 66° Celsius.
Warm:
Mixture of hot and cold water. (Warm water temperature is dependent upon the water temperature and the pressure of both the hot and cold water supply lines.)
IMPORTANT: Turn off water supply faucets after
NOTE: Longer fill hoses are available (as optional equipment at extra cost) if the hoses (supplied with the washer) are not long enough for the installation. Order hoses as follows:
No. 20617 Fill Hose (8 feet) (2.44 m)
No. 20618 Fill Hose (10 feet) (3.05 m)
1 | 2 | 3 |
|
|
WATER
MIXING
VALVE
W293I
W293I
1Fill Hoses
2Cold Water Connection
3Hot Water Connection
Figure 15
Water Pressure
Pressure must be a minimum of 20 to a maximum of 120 pounds per square inch (138 to 827 kPa) static pressure measured at the faucet.
NOTE: Water pressure under 20 pounds per square inch (138 kPa) will cause an extended fill time in the washer.
16 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 38857 |