Installation
Meter Case
The factory mounted coin meter case does not include the service door lock, slide, coin drawer, coin drawer lock or keys. These parts must be ordered (at extra cost) according the purchaser’s requirements direct from the manufacturer of your choice.
NOTE: You have the option of using a screw type lock or a 1/4 turn lock on the meter case service door. If you choose to use a screw lock, then the special bracket (located inside the meter case) must be used. DO NOT use the special bracket if a
1/4 turn lock is used.
Coin Drawer Security – For additional security, drill out the two pilot holes on each side of the front of the meter case to 1/4 or 5/16 inch (6.4 or 7.9 mm) holes and install a bicycle lock through these holes.
NOTE: An 8 in. (20.32 cm) coin drawer is required for coin operated electronic control models.
Models Prepped for Card Reader
The machine is shipped from the factory with the Electronic Control Diagnostic Harness Assembly unplugged. To avoid unauthorized manual programming or vending, perform the following steps.
1.Open service door. Refer to Figure 1.
2.Locate diagnostic harness on electronic control.
3.Plug connectors for “white/black” wire and “red/ blue” wire together.
1
FLW6R
1Service Door
Figure 1
38857 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 7 |