22 | SHOW IGMPSNOOPING ROUTERADDRESS | Patch Release Note |
PCR: 03925 | Module: IPV6 | Level: 3 |
Incorrect debug information was returned when an ICMPv6 PacketTooBig message was received. This issue has been resolved.
PCR: 03928 | Module: IKMP | Level: 2 |
ISAKMP in aggressive mode did not establish a connection when the peer client sent 10 or more payloads. This issue has been resolved.
PCR: 03931 | Module: IPSEC | Level: 3 |
The IPSec configuration was not created correctly when the RADDRESS and LNAME parameters in the CREATE IPSEC POLICY command were used together. This issue has been resolved.
PCR: 03934 | Module: IPSEC | Level: 2 |
The CREATE IPSEC POLICY command failed if the interface specified with the INTERFACE parameter did not have a global IPv6 interface defined. This PCR implements a workaround by using the interface’s
PCR: 03935 | Module: ISAKMP | Level: 3 |
ISAKMP debug messages now correctly output IPv6 addresses when using
IPv6, and IPv4 addresses when using IPv4.
PCR: 03936 | Module: IKMP | Level: 3 |
When ISAKMP was used with IPv6, an incorrect IP address was displayed in the output of the SHOW ISAKMP EXCHANGE command. This issue has been resolved.
PCR: 03938 | Module: IKMP | Level: 3 |
DHEXPONENTLENGTH parameter in the CREATE ISAKMP POLICY command was not accepted when creating ISAKMP policies that used IPv6. This issue has been resolved.
PCR: 03939 | Module: IPV6 | Level: 2 |
When a NeighbourAdvert message containing an anycast target address was received, the device incorrectly performed Duplicate Address Detection. This issue has been resolved.
PCR: 03946 | Module: IPSEC | Level: 3 |
When IPSec was used with IPv6, an incorrect IP address was displayed in the output of the SHOW IPSEC SA command. This issue has been resolved.
PCR: 03949 | Module: IPSEC | Level: 3 |
If a local IP address and remote IP address were not specified in the CREATE IPSEC POLICY command for IPv6 IPSec, the SET IPSEC POLICY configuration was shown unnecessarily in the output of the SHOW CONFIG DYNAMIC=IPSEC command. This issue has been resolved.
PCR: 03952 | Module: SWI | Level: 3 |
MAC address are now deleted from the all the internal tables for ports where the learn limit has been exceeded.
Patch