8 | Patch Release Note |
PCR: 31040 | Module: PIM | Level: 2 |
When two devices are BSR candidates, and have the same preference set with the SET PIM BSRCANDIDATE PREFERENCE command, the device with the higher IP address was not elected as the candidate. This issue has been resolved.
PCR: 31041 | Module: PIM | Level: 3 |
A Prune message sent to an old RP neighbour was ignored when a new unicast route was learned. This issue has been resolved.
PCR: 31042 | Module: PIM | Level: 3 |
On Rapier series switches, an Assert message was not sent after the prune limit expired. This issue has been resolved.
PCR: 31044 | Module: SWI | Level: 4 |
The log message “IGMP Snooping is active, L3FILT is activated” has been changed to “IGMP packet trapping is active, L3FILT is activated”. The revised message is clearer when IGMP is enabled and IGMP snooping is disabled.
PCR: 31052 | Module: FIREWALL | Level: 3 |
The following changes have been made to the ADD FIREWALL POLICY
RULE and SET FIREWALL POLICY RULE commands:
•An IP address range for the IP parameter is now only accepted when enhanced NAT is configured.
•An IP address range for GBLREMOTE parameter is now only accepted when reverse or
•The GBLIP parameter is not accepted for a public interface when enhanced NAT is configured.
PCR: 31058 | Module: NTP | Level: 3 |
When the interval between the NTP server and client exceeded 34 years 9 days and 10 hours, the time set on the client was incorrect. This issue has been resolved.
PCR: 31063 | Module: IPG | Level: 2 |
MVR was not operating if IGMP had not been enabled. This issue has been resolved.
PCR: 31068 | Module: STP | Level: 2 |
A fatal error occurred when the PURGE STP command was executed when STP instances were defined with VLAN members. This issue has been resolved.
Patch
