HOW TO USE DUAL DETERGENT INJECTION
SYSTEM
NOTE: Use only soaps and cleaning solutions designed for pressure washer use. Do not use bleach.
To apply cleaning solutions:
1.Make sure cleaning solution tanks are assembled and all hoses are connected.
2.Turn detergent selection dial arrow to the down (off) position as shown in Fig. 12.
Fig. 12 | Detergent selection dial |
3.Fill cleaning solution tanks with desired cleaning solution. Each tank holds approximately 1 1/4 gallons. NOTE: The cleaning solution/water ratio is 7:1, for every 7 gallons of water pumped, 1 gallon of cleaning solution will be used.
Never fill cleaning solution tanks
with gasoline or other flammable solvent.
4.Turn detergent selection dial toward tank with desired cleaning solution. (see Fig. 13)
Fig. 13
Tank to be used
5.Set
6.After use of cleaning solution the detergent injection system MUST be rinsed, follow the instructions in the Shutting Down paragraph after each use.
NOTE: Cleaning solutions will not siphon when spray wand is in the high pressure setting.
DUAL DETERGENT INJECTION SYSTEM SOLUTION TIPS
1.Each tank may be filled with different cleaning solutions depending on the task to be performed. Example: deck and driveway. Fill one tank with deck cleaning solution and the other with driveway cleaning solution. Clean the deck with the deck cleaning solution. When finished with the deck, simply turn the
detergent selection dial toward the driveway cleaning solution and clean the driveway.
2.a. If only one cleaning solution is being used, both tanks may be filled with the same solution to double the capacity.
b.If only one cleaning solution is being used, the second tank may be filled with clean water to conveniently rinse the detergent injection system after use.
11- ENG | A08989 |
