HOW TO DRAIN THE DUAL- DETERGENT INJECTION TANKS
1.Turn detergent selection dial to the down (off) position.
(See Fig. 25)
Fig. 25
Detergent selection dial
2.Remove cleaning solution hose at detergent injection system (see Fig. 26a) and pull through rear shroud (see Fig. 26b).
Fig. 26a
Fig. 26b
3. Place end of cleaning solution hose into a suitable container to drain cleaning solution. (See Fig. 27)
Fig. 27
4. Turn detergent selection dial toward tank to be drained.
5.Repeat steps
6.Turn detergent selection dial to the down (off) position.
7.Fill tanks with clean water.
8.Turn detergent selection dial toward tank and drain water from tank. Repeat on second tank. NOTE: This will rinse cleaning solution tanks.
9.Feed cleaning solution hose between shroud and wheel bracket making sure it is routed over the axle as shown in Fig.
28a and 28b. Reconnect cleaning solution hose to detergent/ cleaning solution injector for future use.
Fig. 28a
Fig. 28b | Axle |
Hose
PRESSURE WASHER
1.Drain all water from high pressure hose, coil it, and store it in cradle of the pressure washer handle.
2.Drain all water from spray gun and wand by holding spray gun in a vertical position with nozzle end pointing down and squeez- ing trigger.
A08989 | 16- ENG |
