PROBLEM
Engine will not start (see Engine Manual for further engine troubleshooting)
No or low pressure (initial use)
TROUBLESHOOTING GUIDE
CAUSE | CORRECTION |
No fuel. | Add Fuel. |
Pressure builds up after two pulls | Squeeze gun trigger to relieve |
on the recoil starter or after initial | pressure. |
use. |
|
Choke lever in the "No Choke" | Move choke lever to the "Choke" |
position. | position. |
Spark plug wire not attached. | Attach spark plug wire. |
Choke lever in the "Choke" | Move choke lever to the "No |
position on a "hot" engine or an | Choke" position. |
engine that has been exposed to |
|
thermal heat for a long period of |
|
time. |
|
Spray wand not in high pressure. | See How to Use Spray Wand |
| instructions in the Operation |
| Section. |
Low water supply.
Leak at high pressure hose fitting.
Nozzle obstructed.
Water filter screen clogged.
Air in hose.
Choke lever in the "Choke" position.
Throttle control lever is not in the "Fast" position.
High pressure hose is too long.
Water supply must be at least 5 GPM @ 20 PSI.
Repair leak. Apply sealant tape if necessary.
See Nozzle Cleaning instructions in the Maintenance section.
Remove and clean filter.
Turn off the engine, then the water supply. Disconnect the water supply from the pump inlet and turn the water supply on
to remove all air from the hose. When there is a steady stream of water present, turn water supply off.
Move choke lever to the "No Choke" position.
Move throttle control lever to the "Fast" position.
Use high pressure hose under 100'.
17- ENG | A08989 |
