b.Push detergent injection system rinsing hose onto the detergent injection system barbed fitting. (see Fig. 17)

Fig. 17

c.Place other end of detergent injection system rinsing hose into container of clean water and depress trigger to draw at least 1 gallon of clean water through detergent injection system to rinse system thoroughly.

d.Before reconnecting cleaning solution hose to detergent injection system barb fitting, make sure that any remaining cleaning solution has been completely drained from the cleaning solution hose.

To rinse detergent injection system using cleaning solution system tank

a.Turn detergent selection dial arrow to the down (off) position. (see Fig. 18)

Fig. 18

Detergent selection dial

b.Fill one of the cleaning solution system tanks with clean water.

c.Turn detergent selection dial toward tank with clean water. (see Fig. 19)

Fig. 19

Tank to be used

d.Depress trigger to draw clean water through injection system to rinse system thoroughly.

2.Turn engine off. See Engine Owner’s Manual. NOTE: NEVER turn the water off with the engine running.

3.Turn water supply off.

4.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.

5.See Storage section in this manual for proper storage procedures. NOTE: Cleaning solution must be removed from cleaning solution tanks if storing unit longer than 30 days, see Storage section for correct procedure.

13- ENG

A08989

Page 13
Image 13
DeVillbiss Air Power Company A08989, S2600 important safety instructions Detergent selection dial