PROBLEM
CAUSECORRECTION
Will not draw detergent/ cleaning solution
Spray wand not in low pressure.
Filter on end of detergent injection system rinsing hose is clogged.
Screen on end of detergent injection system rinsing hose not in water
Detergent/cleaning solution too thick.
Pressure hose is too long
Detergent/cleaning solution build up in detergent injection system.
Hoses are not connected.
See How to Use Spray Wand paragraph in the Operation Section.
Clean filter.
Make sure end of detergent injection system rinsing hose is fully submerged into clean water.
Dilute detergent/cleaning solution. Detergent/cleaning solution should be the same consistency as water.
Lengthen water supply hose instead of high pressure hose.
Have parts cleaned or replaced by certified mechanic.
Make sure all hoses are connected at valve.
Detergent selection dial is in the | Turn detergent selection dial |
down (off) position or pointed | toward tank being used. |
toward the tank not being uses. |
|
No or low pressure (after period of normal use)
Water leaking at gun/ spray wand connection
Water leaking at pump
Pump
Pulsates
Worn seal or packing Worn or obstructed valves. Worn unloader piston.
Worn or broken
Loose hose connection.
Loose connections.
Piston packings worn.
Worn or broken
Pump head or tubes damaged from freezing.
Nozzle obstructed.
Call: 1 866 474 6664
Call: 1 866 474 6664
Call: 1 866 474 6664
Check and replace.
Tighten.
Tighten.
Call: 1 866 474 6664
Call: 1 866 474 6664
Call: 1 866 474 6664
See Nozzle Cleaning paragraph in the Maintenance section for the correct procedure.
A08989 | 18- ENG |
