6 | Patch Release Note |
Features in
Patch file details are listed in Table 2:
Table 2: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 700793 bytes |
|
|
Patch
PCR: 03781 | Module: STP | Level: 2 |
A buffer leak occurred when rapid STP was specified with the SET STP
MODE=RAPID command, but STP had not been enabled with the ENABLE
STP command. This issue has been resolved.
PCR: 03861 | Module: IPV6 | Level: 2 |
When a connector was plugged into one physical interface, the RIPng request packet was erroneously transmitted from all interfaces on the switch. This issue has been resolved.
PCR: 03873 | Module: IPG | Level: 4 |
The STATIC and INTERFACE options have been removed from the PROTOCOL parameter in the ADD IP ROUTE FILTER and SET IP ROUTE FILTER commands. These parameters were redundant because received static and interface routes are always added to the route table.
PCR: 03905 | Module: TTY | Level: 3 |
A fatal error occurred in the text editor while selecting blocks and scrolling up. This issue has been resolved.
PCR: 03910 | Module: IPG | Level: 3 |
When RIP demand mode was enabled, and one interface changed to a reachable state, the triggered Request packet was not sent from that interface, and triggered Response packets were not sent from all other RIP interfaces. This resulted in slow convergence of routing tables across the network. This issue has been resolved.
PCR: 03926 | Module: PIM | Level: 2 |
Repeated Assert messages were sent after the prune limit expired. This issue has been resolved. The default dense mode prune hold time has been changed from 60 seconds to 210 seconds.
PCR: 03940 | Module: PKI | Level: 1 |
The following two issues have been resolved:
•Large CRL files were not decoded correctly.
•The certificate database was not validated immediately after the CRL file was updated.
Patch