Patch | 5 |
PCR: 31270 | Module: CURE, IPG, ATK, | Level: 3 |
| DVMRP, IPX2, LB, LOG, SNMP, |
|
| UTILITY |
|
Entering “?” after a command at the CLI gives
PCR: 40006 Module: LOG | Level: 2 |
Executing the SHOW DEBUG command caused a fatal error if the temporary log had been destroyed with the DESTROY LOG OUTPUT=TEMPORARY command. This issue has been resolved.
PCR: 40007 | Module: FIREWALL | Level: 2 |
When an
PCR: 40008 | Module: NTP | Level: 3 |
When the device operated in NTP Client mode, the SHOW TIME command sometimes displayed the incorrect time. This issue has been resolved.
PCR: 40012 | Module: IPG, OSPF | Level: 2 |
The device sometimes rebooted when OSPF on demand was enabled for
PPP. This issue has been resolved.
PCR: 40020 | Module: SW56 | Level: 3 |
When a port’s ingress limit was set to less than 1000 with the INGRESSLIMIT parameter in the SET SWITCH PORT command, sending packets to a tagged port caused FCS errors on transmission. This issue has been resolved.
PCR: 40023 | Module: IPG | Level: 2 |
The timeout interval for IGMP group membership now conforms to RFC 2236 for IGMPv2.
PCR: 40038 | Module: OSPF | Level: 2 |
After a Summary LSA for the default route in a stub area had been refreshed by an Area Border Router, and the Area Border Router was restarted, the Summary LSA was not advertised into the stub area again. This issue has been resolved.
Patch