Allied Telesis Figure 41. , Figure 42.

Chapter 6: Powering On and Verifying the Stack
98
Figure 41. DC Terminal Block
3. With a 14-gauge wire-stripping tool, strip the three wires in the tray
cable coming from the DC input power source to 8mm  1mm (0.31 in.,
 0.039 in.), as shown in Figure 42 on page 98.
Warning
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation. E10
Figure 42. Stripped Wire
4. Insert the power supply ground wire into the middle connector of the
DC terminal and tighten the connection with a flathead screwdriver, as
shown in Figure 43 on page 99.
Warning
When installing this equipment, always ensure that the power supply
ground connection is installed first and disconnected last. E11
Positive Ground Negative
TerminalTerminalTerminal