Allied Telesis AT-GS900/16 manual Attaching the switch to the wall

AT-GS900/16, AT-GS900/24 Gigabit eco-friendly Ethernet Switch Installation Guide

3.Place the switch on the wall. Then mount the switch using the plastic anchors and screws which are shipped with the product. See Figure 8.

Warning

The switch must be mounted with the AC Power Connector facing down to conform with UL requirements as shown in Figure 8.

1925

Figure 8. Attaching the switch to the wall

4.Connected the twisted pair cables to the twisted pair ports.

When connecting a twisted pair cable to a port, observe the following guidelines:

ˆAn RJ-45 connector should fit snugly into the port on the switch. The tab on the connector should lock the connector into place.

ˆCheck that you are using the appropriate type of twisted pair cabling. Refer to “Twisted Pair Cabling and Distances” on page 30 for twisted pair cable specifications.

ˆSince the twisted pair port, when operating in Auto-Negotiation, is Auto MDI/MDI-X, you can use either a straight-through or

35