High Temperature
•Protective circuit is activated due to high temperature.
-The indication will disappear when the temperature returns to normal operating range.
No Disc
•No CD is inserted.
-Insert a CD.
•Although a disc is inserted, "No Disc" is displayed and the unit does not start to play or eject the disc.
-Remove the disc by following these steps: Press the ~ button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
Error
•Mechanism error.
1)Press the ~ button and eject the CD.
If not ejecting, consult your Alpine dealer.
2)When the error indication remains after ejecting, press the ~ button again.
If the error indication still does not turn off after pressing the
~button for a few times, consult your Alpine dealer.
•When "Error" is displayed:
If the disc cannot be ejected by pressing ~, press the RESET switch (refer to page 7) and press ~ again.
If the disc still cannot be ejected, consult your Alpine dealer.
Error 01
•Malfunction in the CD Changer.
-Consult your Alpine dealer. Press the magazine eject button and pull out the magazine.
Check the indication. Insert the magazine again.
If the magazine cannot be pulled out, consult your Alpine dealer.
•Magazine ejection not possible.
-Press the magazine eject button. If the magazine does not eject, consult your Alpine dealer.
Error 02
•A disc is left inside the CD Changer.
-Press the eject button to activate the eject function. When the CD Changer finishes the eject function, insert an empty CD magazine into the CD Changer to receive the disc left inside the CD Changer.
No Magazine
•No magazine is loaded into the CD Changer. - Insert a magazine.
No Disc
•No indicated disc.
- Choose another disc.
PROTECT I
•A
- You can only play back
IUNSUPPORTED I
•A sampling ratelbit rate not supported by the unit is used. - Use a sampling ratelbit rate that is supported by the unit.
High Temperature
•Protective circuit is activated due to high temperature.
-The indication will disappear when the temperature returns to normal operating range.
ANTENNA
•The XM or SIRIUS antenna is not connected to the XM or SIRIUS radio module.
-Check whether the XM or SIRIUS antenna cable is attached securely to the XM or SIRIUS radio module.
I UPDATING I
•Radio is being updated with latest encryption code.
-Wait until encryption code is being updated. Channels 0 and 1 should function normally.
INO SIGNAL I | (XM mode) |
J ACQUIRING SIGNAL I | (SIRIUS mode) |
•XM or SIRIUS signal is too weak at the current location.
- Wait until the car reaches a location with a stronger signal.
LOADING
•Radio is acquiring audio or program information. - Wait until the radio has received the information.
