Installation
Caution
Do not block the unit's fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Air ventilation hole
~~Detachable Front
V Panel
Caution
When you install this unit in your car, do not remove the detachable front panel.
If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.
•The main unit must be mounted within 35 degrees of the horizontal plane, back to front.
~,/:/~,;
Less than 35°-:,""", ,
a "'",J,:
Mounting Sleeve
1 (Included)
Dashboard
~
Pressure Plates*
*If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem.
Remove the Detachable Front Panel (refer to
page 6). Remove the mounting sleeve from the main unit (see "Removal" on page 39).
2 | Hex Nut (M5) | Screw |
Metal
Mounting
Strap
Ground Lead
Chassis
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle'schassis.
•For the screw marked" *2 ", use an appropriate screw for the chosen mounting location.
Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the
3
Slide the
Install the detachable front panel.
Removal
1.Remove the detachable front panel.
2.Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve.
This unit
~~ Bracket keys
.. ~ (Included)
~
3. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
~~
~+R
| Front Frame | |
This unit | Screws (M5 x 8) | |
(Included) | ||
|
•Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle's chassis.
