Alpine CVA-1003R Installing the Monitor, 48-EN, Installation and Connections, Location

Installation and Connections

Installation

NOTE

For the screw marked , use an appropriate screw for the chosen mounting location.

Installing the Monitor

• Location

3

Before final installation, make sure the display will not hamper gear shifting when it is opened and closed in the chosen location.

NOTE

Install at an angle within 30 degrees from horizontal.

1

Bracket Mounting Sleeve (Included)

Dashboard

Hex Bolt

(Included) Mounting Bracket

CVA-1003R (Included)

Rubber Cap (Included)

Screws(M4x5)

(Included)

Lock Pin

Slide the CVA-1003R into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Supplied Front Frame.

Removal

1Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does

not re-lock before unlocking the second pin.

2Pull the unit out, keeping it unlocked as you do so.

Slide mounting sleeve from main unit (see Removal Procedure below). Slide the mounting sleeve into the dashboard. Install the supplied bracket to the monitor.

<JAPANESE CAR>

Installation using the vehicle's Factory brackets.

CVA-1003R

Ground Lead

2

Hex Nut (M5)

Ground Lead

Chassis

Screw

Metal Mounting Strap

Bolt Stud

CVA-1003R

Front Frame (Included)

Screws (M4x5)

Mounting Bracket

When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the CVA- 1003R and put the Rubber Cap on the hex bolt. If your vehicle does not have the Mounting Support, reinforce the monitor unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw () already attached to the vehicle's chassis.

48-EN