iDA-X200
Double Action encoder | FUNC./SETUP |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SOURCE |
|
| /ENTER | VIEW | ||||
|
|
|
|
|
|
| |||||
|
|
|
|
|
| ||||||
|
|
|
|
|
| Rotary encoder | FUNC./SETUP | ||||
|
|
|
|
|
|
| SOURCE | /ENTER | VIEW |
Accessory List |
|
| |
• | Digital Media receiver........................................................ | 1 | |
• | Power cable ........................................................................ | 1 |
•FULL SPEEDTM Connection Cable
| 1 | |
• USB cable | 1 | |
• iPod Dock interface cable | 1 | |
• | Mounting sleeve................................................................. | 1 |
• | Carrying case..................................................................... | 1 |
• | Bracket key......................................................................... | 2 |
• | Screw (M5x8)...................................................................... | 4 |
• | Owner’s Manual .......................................................... | 1 set |
Turning Power On and Off
Press SOURCE to turn on the unit.
•The unit can be turned on by pressing any other button except
(Release), Double Action encoder
Press and hold SOURCE for at least 2 seconds to turn off the unit.
•The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Detaching
1 Turn off the unit power.
2 Press (Release) at the middle left side until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction.
•To protect the front panel, place it in the supplied carrying case.
Attaching
1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
•Attach the front panel carefully. Hold the panel by its sides to avoid pushing any buttons by mistake.
Initial System
Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc.
1 Turn off the unit power.
2 Press (Release) to remove the front panel.
3 Press RESET with a ballpoint pen or similar pointed object.
Adjusting Volume
Turn the Double Action encoder