Alpine PMD-B100T owner manual Case of Difficulty, Vehicle’s position is erroneous

261985 PMD-B100_r15.qxd 9/13/06 3:16 PM Page 36

IN CASE OF DIFFICULTY

If you encounter a problem, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise make sure the rest of your system is properly connected, batteries are completely charged and contact your author- ized Alpine dealer or Alpine directly at 1-888-NAV-HELP (1-888-628-4357).

The vehicle’s position is erroneous.

Reset the unit and drive the vehicle in an area of good GPS reception to allow the unit to recalibrate itself. Move to a location where strong GPS reception is possible.

No operation

·Moisture condensation ➔ Allow enough time for the condensation to evapo-

rate (about 1 hour).

·Ambient temperature ➔ Lower the temperature in the vehicle to

over 113°F (45°C)	below 113°F (45°C) by driving with the windows
	open or air conditioner on.
· Blown fuse	➔ Replace with a fuse of the prescribed rating (2A
	glass-type fuse located in the head of the ciga-
	rette lighter adapter).

The unit is taking a long time to acquire GPS signal.

It may take a long time for the unit to acquire GPS signal if it has been powered on in an area that is more than 200 miles from the area where it was last powered off. Following these steps will speed the process by resetting the GPS receiver:

1Go to GPS Status screen (See instructions on page 33)

2Press and hold the Down Arrow (Map Zoom Out Button) for 2 seconds

3A message appears to indicate that the GPS receiver is resetting.

Low RDS Traffic Signal (for Traffic Service Users)

In order to improve the RDS Traffic signal strength, you may need to separate the RDS antenna away from the power cord on the Cradle. Carefully follow these instructions:

1Power off the unit and unplug the Cigarette Lighter Charger.

2Identify the RDS antenna. It is the thin, black, insulated wire that runs the full- length of the thicker power cord. (See diagram on page 9)

3 Carefully cut the thin RDS antenna at the point where it enters the connector that attaches it to the Cigarette Lighter Charger.

4

5

Slowly peel the antenna away from the power cord to leave about 50 inches of the antenna separated and hanging free.

Place antenna on the vehicle dashboard or for best results, mount the antenna to the windshield using the provided suction cups (please see suction cup instructions for details)

36