Basic Operation
POWER/SETUP 2 | MODE/LOUD c | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 | 1 |
Detaching the Front Panel
1 Press the POWER button to turn off the power.
2 Press the 
(Release) button until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
NOTES
•The front panel may become hot (especially the connector terminals), this is not malfunction.
•To protect the front panel, place it in the supplied carrying case.
•Connectable to Remote Control Interface Box
You can operate this unit from the vehicle's control unit when an Alpine Remote Control Interface Box (optional) is connected. For details, contact your Alpine dealer.
Initial System Start-Up
1 Immediately after installing or applying power to the unit, it should be initialized. To do this, first, remove the detachable front panel. Behind the front panel, to the right of the connector, there is a small hole. Using a ballpoint pen or other pointed object, press the RESET switch mounted behind this hole to complete the initialization procedure.
RESET Switch
Attaching the Front Panel
1 First, insert the right side of the front panel into the main unit. Align the groove on the front panel with the projection on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
2 |
1 |
NOTE
Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
