Alpine TDM-7581R Antenna Receptacle, Audio Interrupt In Lead Pink/Black, Power Antenna Lead Blue

1Antenna Receptacle

Connect to the supplied ISO antenna convertor plug.

2Audio Interrupt In Lead (Pink/Black)

Connect this lead to the Audio Interface output of a cellular phone which provides ground shorting when a call is received.

3Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on lead of your amplifier or signal processor.

4Power Antenna Lead (Blue)

Connect this lead to the +B terminal of your power antenna, if applicable.

NOTE

This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc.

5Switched Power Lead (Ignition) (Red) Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+) 12V only when the ignition is turned on or in the accessory position.

6Fuse Holder (15A)

7Battery Lead (Yellow)

Connect this lead to the positive (+) post of the vehicle's battery.

8ISO Power Supply Connector

9Ground Lead (Black)

Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.

!Remote Control Interface Connector (TDM-7583R only)

To remote control interface box.

"Rear Output RCA Connectors RED is right and WHITE is left.

#DIN Connector

Connect this to the DIN connector on the CD Changer.

$ DIN Extension Cable

NOTE

Older Alpine CD Changer came with standard, straight type DIN connectors. In installations where an L-type connector would simplify installation, the Alpine 491002 Adaptor can be used (Sold Separately).

%Power Supply Connector

&ISO Connector (Speaker Output)

( Left Rear (+) Speaker Output Lead (Green)

) Left Rear (–) Speaker Output Lead (Green/

Black)

~Left Front (+) Speaker Output Lead (White) + Left Front (–) Speaker Output Lead (White/

Black)

, Right Front (–) Speaker Output Lead (Grey/

Black)

- Right Front (+) Speaker Output Lead (Grey)

. Right Rear (–) Speaker Output Lead (Violet/

Black)

/ Right Rear (+) Speaker Output Lead (Violet) : RCA Extension Cable (Sold Separately)

To prevent external noise from entering the audio system.

•Locate the unit and route the leads at least 10cm away from the car harness.

•Keep the battery power leads as far away from other leads as possible.

•Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis.

•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information.

•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

23-EN