
Turning Power On and Off
1 Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except the eject c button.
The volume level gradually increases to the previous level you were listening to before the unit was turned off.
Press the POWER button again to turn off the unit.
NOTE
When the power is turned on for the very first time after the unit is connected to the vehicle's battery, the unit produces sound with the volume level 12, loudness on in the tuner mode.
Non Fading Pre-out (N.F.P.) On and Off (TDM-7583R only)
1 Press and hold the Eject (c) button for at least 3 seconds.
With each press, N.F.P. is toggled On or Off.
N.F.P. ON:
In this position, the
N.F.P. OFF:
Returns to normal fader mode.
NOTES
•Initial mode is N.F.P. OFF.
•Set the N.F.P. to OFF unless the subwoofer is used.
Adjusting Source Signal Levels
If the difference in volume level between the tape player and FM radio is too great, adjust the FM signal level as follows.
1 Press and hold the SETUP button for at least 3 seconds.
2 Press the Preset 1 button to select the FM signal level HI (High) or LO (Low) to make the signal levels between the FM band and tape player closer.
Each press toggles between
3 Press the SETUP button to cancel the adjusting mode.
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right
Channels)/Fader (Between Front
and Rear Speakers)
1 Press the MODE button repeatedly to choose the desired mode.
Each press changes the modes as follows:
→ |
|
| → |
|
| → |
|
| ||
|
|
| TREB |
| ||||||
VOL |
| BASS |
|
| ||||||
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
| |
|
|
| FAD ← |
|
| BAL ← |
|
| ||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
NOTE
If the 6 or 5 button is not pressed in 5 seconds after selecting the BASS, TREBLE, BALANCE and FADER modes, the unit automatically sets in the VOLUME mode.
2 Press the 6 and 5 buttons until the desired sound is obtained in each mode.
NOTE
The settings of the Bass and Treble will be individually memorized for each source (FM, MW, LW, Tape and CD Changer) until the setting is changed.
Depending on the connected devices, some functions and display indications do not work.
Turning Loudness On/Off
1 Press and hold the LOUD button for at least
2 seconds to activate or deactivate the loudness mode. The display shows "LD" when the loudness mode is activated.