Alpine TDM-9505RB, TDM-9501RM, TDM-9503R owner manual Installation, 21-EN

Installation

1 Remove the Detachable Front Panel (refer to page 4). Slide mounting sleeve from main unit. (See Removal Procedure) Slide the mounting sleeve into the dashboard.

Bracket

Dashboard

Rubber Cap (Included)

Hex Bolt (Included)

Mounting Sleeve (Included)

TDM-9505RB/TDM-9503R/

TDM-9501RM/TDM-9501R

2 When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the TDM- 9505RB/TDM-9503R/TDM-9501RM/TDM-9501R and put the Rubber Cap on the hex bolt. If your vehicle does not have the Mounting Support, reinforce the head unit with the metal mounting strap (not supplied). Connect all the leads of the TDM-9505RB/TDM-9503R/TDM-9501RM/TDM- 9501R according to details described in the CONNECTIONS section.

NOTE:

For the screw *, provide a proper screw to the chassis installing location.

Metal Mounting Strap

Screw

∗Bolt Stud

Hex Nut (M5)

TDM-9505RB/TDM-9503R/

TDM-9501RM/TDM-9501R

3 Slide the TDM-9505RB/TDM-9503R/TDM- 9501RM/TDM-9501R into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Lock pin

Removal

1Remove the detachable front panel.

2Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Face Plate

TDM-9505RB/TDM-9503R/

TDM-9501RM/TDM-9501R

Screws (M5 × 8) (Included)

Mounting Bracket

21-EN