MULTITASKER
7.3SUMMARY OF COMMANDS Basic Commands
1) | [VER] | Display software version |
2) | [C] | Display card status (short) |
3) | [CnS] | Save all card settings |
4) | […S] | Save one command setting |
5) | [SIO] | Display card status (long) |
6) | [CLR] | Reset card to defaults |
7) | [TEST] | Test internal memory ICs |
8) | [HELP] | Display help file |
Feedback Control | ||
9) | [FBD] | Feedback delay on/off |
10) | [?] | Display system information |
11) | [?C] | Display card information |
12) | [AFB] | Enable/disable feedback |
13) | [ACK] | Display acknowledge, [ ] |
14) | [STA1] | Enable |
15) | [STA0] | Disable |
16) | [...F] | Display OK after command |
Matrix Setup |
| |
17) | [MAT] | Set matrix configuration |
18) | [MjCn] | Select matrix configuration |
19) | [MODE] | Turn blocking on/off |
Card Control |
| |
20) | [ONmm] | Turn on one output |
21) | [ON] | Turn on all outputs |
22) | [OFFmm] | Turn off one output |
23) | [OFF] | Turn off all outputs |
24) | [ImmOxx] | Connect |
25) | [ImmO*] | Switch |
26) | [INmmS] | Display outputs on input |
27) | [OUTmmS] | Display input on output |
28) | […P] | Preload path for [SW] |
29) | [SW] | Switch preloaded path |
30) | [SEL] | Set path for volume adjust |
31) | [+] | Increment volume |
32) | Decrement volume | |
33) | [VOL] | Set absolute volume |
34) | [SDI] | Input signal detect |
35) | [SDO] | Output signal detect |
ID Commands |
| |
36) | [RSI] | Reset Card IDs to default |
37) | [SIDn] | Set all Card IDs |
38) | [SIDnCi] | Set one Card ID |
39) | [SID+] | Set all Card IDs to an offset |
40) | [RSN] | Display card slot number |
Group Commands | ||
41) | [WR] | Add card(s) to a group |
42) | [RMC] | Remove card(s) from group |
43) | [RMG] | Delete group |
44) | [RD] | Display group members |
23 |
