MULTITASKER™
Cause 2: The card settings are wrong.
Solution: Verify the card volume settings are at maximum and that mute is off. (See section 7). If no sound is present, see Cause 3.
Cause 3: Cable connections are incorrect.
Solution: Make sure the cables are connected properly and that the continuity and wiring are good. If there is still no sound present, see Cause 4.
Cause 4: The destination amplifier is bad.
Solution 1: Make sure that the destination amplifier is powered. If there is still no sound, see Solution 2
Solution 2: Set the volume of the destination amplifier to a reasonable level. If there is still no sound, call ALTINEX at (714)
8.3 SOUND DISTORTION
Cause 1: Source level is above 1Vp-p.
Solution1: Verify the source level is below 1
8.4 SOUND LEVEL IS LOW
Cause 1: Volume levels are inappropriate.
Solution 1: Turn up the source volume. If sound level is still low, see Solution 2.
Solution 2: Increase the destination amplifier volume. If the sound level is still low, see Cause 2.
Cause 2: Poor signal transmission.
Solution: Check the cables for continuity. Verify the connections are wired properly and that there is good signal transmission. NOTE: Test the system by removing the card from between the source and the destination amplifier. If the problem
persists, call ALTINEX at (714)
ALTINEX POLICY | 9 |
9.1 LIMITED WARRANTY/RETURN POLICY
Please also see the Altinex website at www.altinex.com for details the on warranty and return policies.
9.2CONTACT INFORMATION ALTINEX, Inc.
592 Apollo Street
Brea, CA 92821 USA
TEL: 714
TOLL FREE:
FAX:
WEB: www.altinex.com
E-MAIL: solutions@altinex.com
23 |