MULTITASKER™
NOTE: In MTSetup™, send the command [VER] from the Terminal Window. The system will respond with feedback similar to the following:
Check the last three digits against the numbers above to determine if the option is available.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
The
All status feedback is enclosed in brackets, “[ ]“. Each data field within the status is enclosed in parentheses. The first two characters identify the status type. The last three characters are the card’s ID.
= Card Type | |
= Firmware version | |
VO16 | = Output Volume Level=16 |
VI161616 | = Input volume levels |
VB08 | = Bass level = 08 out of 16 |
VT08 | = Treble level = 08 out of 16 |
VL01 | = Loudness (00=ON, 01=OFF) |
VM0 | = Mute (0=OFF, 1=ON) |
The Input Volume status line is read from left to right as outputs one through three. Each volume level is 2 digits, in this case, each is set to 16.
6.[STA]
This command enables/disables automatic feedback from the front panel. The command affects any card with
Command Format [STA1] = ON
Command Format [STA0] = OFF
Feedback Prefix Definitions:
VR | = | Firmware Version |
VO | = | Output Volume |
VI | = | Input Volume |
VB | = | Bass Volume |
VT | = | Treble Control |
VL | = | Loudness Control |
VM | = | Mute Control |
Example:
Command = [VLOA12C04]
Feedback = (VO12C04)
VO = Output Volume
12= Output volume level12
C04 = Card slot number
7.[…S] – SAVE
This command will save the configuration
command being sent in memory. When sending the command [VLBA12C4S], after reset or power up, the bass level on C4 will be 12 out of 16.
8.[…F] – FEEDBACK
After processing a command, an OK or ER will be returned as feedback if "F" is included at the end of some command strings.
9.[ + ] and [ - ]
These commands allow a selected property to be adjusted from keyboard commands or programmed front panel buttons.
Command Format: [ + ], [ - ]
[+] = Increment level by one step
11 |