Alto-Shaam 100-HW/D443, 400-HW/D4, 400-HW/D6 manual Remote Control Housing Mounting Instructions

I N S T A L L A T I O N

REMOTE CONTROL HOUSING MOUNTING INSTRUCTIONS

100-, 200- & 300-HW 400- & 500-HW

PAN DIVIDER

BARS #16019

FLEXIBLE WATER-

TIGHT TETHER

FLEXIBLE WATER-

TIGHT TETHER

Apply a food grade silicone along the outside edge of the hot well support flange.

DECOR FACE SCREWS

1.100-HW, 200-HW or 300-HW: Cut a 5-1/4" x 4-1/2" (133mm x 114mm) opening in the location where the control is to be positioned.

400-HW or 500-HW:Cut a 9-1/8" x 4-1/2" (232mm x 114mm) opening in the location where the control is to be positioned.

2.Thoroughly clean and dry the mounting surface around the control cut-out opening on which the décor face will be applied.

NOTE: The control face will not properly adhere to an unclean surface.

3.Remove the knob(s) from the thermostat(s) by pulling knob away from control. Remove the décor face from the unit by removing one screw located to the right of the thermostat.

(Two screws for double pod.) See diagram above.

4.Route control housing through opening cut in step 1. Secure the décor face housing to the control housing using the screw(s) removed in step 3.

5.Remove the protective film from the mounting tape on the inside flanges of the décor face and apply the décor face to the mounting surface. Two holes are provided in décor face for additional mounting screws (not provided) if desired.

6.Reattach the knob(s) to the thermostat(s).

Hot Food Drop-In Well Operation & Care Manual • 6