I n s t a l l a tio n
s t a c king instructions
A rotisserie with ventless hood can be stacked on top of a matching holding cabinet.
Only screws, lock washers, and hex nut are required to fasten units together when stacking a rotisserie on top of a matching holding cabinet.
All fastening holes have been prepunched. The stacking combination also requires the minimum clearance of
1.Attach 4: Support Brackets (1010092) and any required feet or
casters (varies) with 4: | 7 |
the bottom unit.. |
|
2.Remove the access panels of both units.
3.Punch out the knock out hole (A) in the top panel of the lower unit.
4.Remove power cord from upper unit and discard.
5.The new power cord and strain relief bushing for upper unit should be routed through the knock out hole in the top panel of the lower unit.
6.Carefully lift and place the upper unit into position aligning on bottom unit.
7.Secure units together by inserting a hex head screw and washer inside upper unit, and back them with a washer,
8.Attach a strain relief bushing to the bottom panel of the lower unit to the left of the existing power cord. (B)
9.Route power cord from upper unit through the strain relief bushings, then tighten bushings.
10.Replace the access panels on both units.
8
A
8
10
5
3
B
2
1
9
11
6
item | part | part description | qty | |
no. | no. | |||
|
| |||
1 | 1010092 | bracket, support, base | 4 | |
|
|
|
| |
2 | bushing, strain relief, | 1 | ||
|
|
|
| |
3 | cord, 8/4 seeo | 1 | ||
|
|
|
| |
4 | connectors, *CT, ring, 10mm, sq/m6 | 4 | ||
|
|
|
| |
5 | nut, | 4 | ||
|
|
|
| |
6 | screw, hex head, | 16 | ||
|
|
|
| |
7 | screw, 1/4/20 x 3/4" lg hex head | 4 | ||
|
|
|
| |
8 | WASHER, 1/4", FLAT, 5/8 OD | 8 | ||
|
|
|
| |
9 | WASHER, 3/8" id, 1" OD, Flat, | 16 | ||
|
|
|
| |
10 | lock washer, 1/4" | 4 | ||
|
|
|
| |
11 | lock washer, 5/16" | 16 | ||
|
|
|
|
*not shown
