Amana AOES2430 owner manual Before You Call for Service

Before You Call for Service

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

This oven is equipped with an electronic oven controller. Among its many features is a full time oven circuit diagnostics system. The controller constantly monitors its internal circuitry as well as several crucial oven circuits, to insure they are all operating correctly. If at any time one of these systems fail, the controller will immediately shut down operation, and will beep and flash an error code of -F1- or -F3- in the display window.

OCCURRENCE	POSSIBLE CAUSE/SOLUTION
Oven Control Beeps and	Electronic control has detected a fault condition. Push OVEN CANCEL pad to clear
Displays -F1- or -F3-.	the display and stop the display from beeping. Reprogram the oven. If a fault recurs,
	record the fault number, push OVEN CANCEL pad and contact an authorized
	servicer.
Oven is not level.	Poor installation. Place a level on an oven rack in center of oven. Contact installing
	agent if rack is not level; unit may be shimmed underneath. Refer to Installation
	Instructions.
Entire appliance does not	When the oven is first plugged in, or when the power supply to the oven has been
operate.	interrupted, the display will flash. The oven cannot be programmed until the clock is
	set to the time of day.
	Make sure electrical cable is securely connected and grounded into electrical circuit.
	Service wiring not complete. Contact your dealer, installing agent or authorized
	servicer.
	Power outage. Check house lights to be sure. Contact your local electric company.
	Short in electrical cable. Contact your dealer, installing agent or authorized servicer.
	Electronic controls are not set properly. See instructions under “Programming”
	section.
	House fuse has blown or circuit breaker has tripped immediately following
	installation. House fuse may not be fully engaged. Check fuse or engage circuit
	breaker securely.
	House fuse has blown or circuit breaker has tripped after the oven has been installed
	and previously operating. Call an authorized servicer.
Oven light does not work.	Burned out or loose bulb. Follow instructions under “Changing Oven Light” to replace
	or tighten the bulb.

19