Adjusting Oven Height
Oven height can be adjusted when needed to fit into an existing cabinet cutout opening. To adjust oven height:
1.Lay the oven on its back.
2.Remove the 6 screws fastening the side of each extension panel to the bottom sides of the oven.
3.Move each panel down to the position that increases the oven height to fit the existing cutout opening. Each position changes oven height approximately 1/2 inch up to 2 inches.
4.Line up the appropriate holes in the side extension panels and sides of the oven. Replace the 6 screws.
5.Proceed with oven installation. Return oven to upright position.
Oven door
Oven bottom | Extension panel |
| |
|
|
Figure 5 – Extension Panel |
|
Cabinet Installation
!CAUTION
Do not lift the oven by the door handle. Preferably, remove the oven door to facilitate handling and prevent damage to the appliance.
Slide the oven all the way into the cabinet opening. Check for level installation with a level on the oven rack. In wood cabinets, drill
Locate lower grill assembly and trim adaptors that were removed during unpacking. Carefully break apart the trim adaptors and insert them in each side of the lower grill assembly. Insert the protruding end of the trim assembly into the oven side trim, sliding the assembly up from the bottom. Secure the grill assembly to the cabinet with the two Fillister screws provided.
Fit trim adapter (one each side)
2" Fillister screw
Slide and fit lower grill assembly into oven side trim
Figure 6
Checking Operation
Upon completion of the electrical hookup, the operation of the electronic oven control should be verified. The Bake, Broil, and Clean modes should be checked by operating the electronic control according to the instructions contained in this manual .
7
