Manuals / Brands / Kitchen Appliance / Freezer / American Panel / Kitchen Appliance / Freezer

American Panel AP120BC1000-3, AP120BCF1300-3 6. DEFROST CYCLE

1 50

Download 50 pages, 4.28 Mb

AP120BC1000-3/ AP120BCF1300-3 Manual

6. DEFROST CYCLE

The defrost cycle runs the evaporator fan for 5 minutes

with the door open

a. To perform a defrost cycle, press the

("DEFROST") button.

b. Open the door.

c. Press the ("START/STOP") button to start the

defrost cycle.

READY TO

START

Blinks

The display will show briefly:

Then the display will now show:

14:59

Will count

down to

00:00

OPERATING MODE

CHOOSE

OPERATING CYCLE

03.07.2006 12:15 PM

DEFROST CYCLE

READY TO START

03.07.2006 12:15 PM

DEFROST CYCLE

OPEN THE DOOR!

STARTING CYCLE . . .

After 5 minutes the display will show:

The controller will beep for a few seconds.

COMPLETE

Blinks

03.07.2006 12:15 PM

DEFROST CYCLE

DEFROST TIME 14:59

The operator can now end this cycle by pressing ("START/ STOP").

Then the display will show:

03.07.2006 12:20 PM

DEFROST CYCLE

COMPLETE

OPERATING MODE

CHOOSE

OPERATING CYCLE

Contents

Main USERS MANUAL INDEX Page INTRODUCTION CONTROLLER FEATURES OPERATING MODES OPERATING CYCLES PRINTER (OPTIONAL) PC CONNECTION (OPTIONAL) INSTALLATION OF REMOTE UNITS REQUIREMENTS TO BE MET DURING INSTALLATION (8 STEPS) INSTALLATION AT THE SAME LEVEL INSTALLATION AT DIFFERENT LEVELS CONNECTION PIPING FOR REMOTE CONDENSING UNITS 7 INSTALLATION WARNINGS PREPARATION INSTALLATION LOCATION VERIFYING CORRECT INSTALLATION 9 SPACES AROUND THE CABINET 10 STARTING & TESTING THE UNIT USING THE HURRICHILL TECHNOLOGY BLAST CHILLING SHOCK FREEZING SOFT CHILL CYCLE PANNING AND LOADING PANNING LOADING CONTROL PANEL FOR MODELS AP120BC1000-3 / AP120BCF1300-3 BLAST CHILLERS / SHOCK FREEZERS KEYBOARD KEYS KEY COMBINATIONS PROGRAMMING 1. INITIAL PROGRAMMING Page Page Page 19 2. PROGRAMMING THE CYCLES AUTOMATIC SOFT CYCLE PARAMETERS PROGRAMMING 20 AUTOMATIC HARD CYCLE PARAMETERS PROGRAMMING 21 AUTOMATIC SHOCK CYCLE PARAMETERS PROGRAMMING 22 UV LIGHT CYCLE PARAMETERS PROGRAMMING DEFROST CYCLE PARAMETERS PROGRAMMING 23 HEATED PROBE CYCLE PARAMETERS PROGRAMMING MANUAL SOFT CYCLE PARAMETERS PROGRAMMING 24 MANUAL HARD CYCLE PARAMETERS PROGRAMMING 25 MANUAL SHOCK CYCLE PARAMETERS PROGRAMMING Page 3. RECIPE NAME PROGRAMMING OPERATION 1. AUTOMATIC MODE - SOFT CHILL Page 2. MANUAL MODE - SOFT CHILL 3. HARD CHILL CYCLE 4. SHOCK FREEZE CYCLE 5. OPTIONAL UV (STERILIZATION) CYCLE 6. DEFROST CYCLE 7. HEATED FOOD PROBE 8. PREPARING AND USING THE OPTIONAL PRINTER 9. TO CLEAR DATA PRINTER LOADING A ROLL OF PAPER REMOVING A ROLL OF PAPER OPERATING THE PRINTER MAINTENANCE REPLACING THE RIBBON (NO PAPER IN THE PRINTER) REPLACING THE RIBBON (WITH PAPER IN THE PRINTER) MAINTENANCE AND CLEANING CLEANING THE CONDENSER CLEANING THE STORAGE COMPARTMENT WIRING DIAGRAMS Page Page Page Page Page Page Page COMPUTER CONNECTION PARTS LIST 48 STANDARD WARRANTY AMERICAN PANEL CORP. 5800 S.E. 78th Street, Ocala, Florida 34472-3412 installing contractor. It is not covered by this Warranty. ORDERING PRINTER SUPPLIES (RIBBON & PAPER)