American Power Conversion AP9615 Installing the Hub, Management Accessories on Critical Systems

Installing the Hub

Warning	Do not operate the 5 Port 10Base-T Hub where conditions
	are outside the limits listed in “Product Specifications” on
	page 14.
Installing on	The installation procedure that follows may involve shut-
critical systems	ting off power from the UPS. However, if your setup
	requires maintaining power to connected equipment
	throughout installation, visit the support page on our Web-
	site
	(http://www.apcc.com/support/#kbase) and follow the
	appropriate procedure in Installation Instructions for APC
	Management Accessories on Critical Systems.
Installation	To install the 5 Port 10Base-T Hub, perform the following
procedure	steps in the order given.
	Note: The Smart-UPS, Matrix-UPS, Symetra Power Array,
	Smart-UPS DP, and Triple Chassis for Silcon require
	different procedures to turn off the UPS or device that
	will host the hub.
	1 To turn off the UPS or device that will host the hub,
	follow the appropriate procedure listed below:
	Smart-UPS®
	a Shut down and power off the connected equip-
	ment.
	b Press and hold the UPS’s Power Off button
	until you hear a click or until the UPS’s power
	LED extinguishes.
	c Unplug the UPS from the AC power outlet.
	d Press and hold the UPS’s Power Off button
	until you hear a click (hold for at least 5 sec-
	onds).
	Continued on next page

5