Installing the Hub continued
Installation | 3 Use a #2 Phillips head screwdriver to remove the 2 |
procedure, | screws fastening the SmartSlot cover plate to the |
continued | back panel of the UPS or triple chassis. Keep the |
| screws for Step 5 below. Save the SmartSlot cover |
| plate for future use (e.g. shipping the UPS). |
| 4 Orient the hub to fit into the SmartSlot. Slide the hub |
| all the way into the slot until its front panel is flush |
| with the back panel of the UPS or triple chassis. |
| Observe the correct orientation as shown in Figure 3. |
| Note that the sides of the circuit board align with the |
| card guides of the SmartSlot. |
| Note: While it is not possible to install the hub |
| upside down, it is possible to damage the |
| unit in the attempt to do so. |
Figure 3: Orient the hub to fit into the SmartSlot.
. | Continued on next page |
7
