20 Pre-Installation WAVE 2-Way Wireless Accessories and Adapters for Touch Panels
The 4-position Group ID DIP switch (Figure 22) sets the group identification number
to synchronize communication between the wireless WAV-PKM and the AXR-
WAVES (or WAV-LNK). Each AXR-WAVES (or WAV-LNK) must have a unique
group ID number and each WAV-PKM must have its 4-position group ID DIP
switch set to the same value as the AXR-WAVES group ID value.
If the AXR-WAVES (or WAV-LNK) and WAV-PKM group ID switches are not set to
the same values, valid communications will not occur.
The group ID DIP switch for the WAV-PKM is located under the top cover of the
unit. (To gain access to the DIP switch, refer to Installing the WAV-PKM subsection
of this manual for gaining access to the DIP switch.)
1
2
3
4
ON
Charging the WAV-BP or WAV-BPM WavePack battery is accomplished with the
battery still inside the WAV-PK (or the WAV-PKM), or by removing the battery and
recharging it in the optional WAV-PM WaveLink Power Module (for WAV-BP
batteries only), WAV-CHG Fast-Cycle Battery Charger, or the WAV-PM WaveLink
Power Module. The WAV-PK and WAV-PKM have built-in charging circuitry and
can recharge a battery in approximately 4 hours. Optionally, two batteries can quick-
charge in a WAV-CHG Fast-Cycle Battery Charger is used (Figure 23).
The optional WAV-CHG Fast-Cycle Battery Charger charges two batteries at the
same time, or one at a time. With multiple batteries, you can use one battery and
charge up to two more. The WAV-CHG produces a full charge for one or two batter-
ies in approximately 4 hours.
Figure 22
WAV-PKM GROUP ID DIP
switch location
Note
The WAV-BP or WAV-BPM
battery must be charged be-
fore use. Either battery will
require a minimum 4-hour
charge.
Caution
Keep the following important
safety considerations in mind
when using the WAV-BP and
WAV-BPM batteries:
• Do not incinerate.
• Do not directly connect the
negative and positive ter-
minals.
• Do not use with battery
chargers other than the
WAV-PK and WAV-PKM.
Group ID DIP switch
Battery compartment
To mini-touch panel
Battery cover