AMX ViewStat manual Setting the DIP Switch, Reassembly, DIP Switch Settings, Application Switch

ViewStat Installation and Wiring

Setting the DIP Switch

Set the DIP switch located on the thermostat circuit board (FIG. 4) according to the application needs (see the DIP Switch Settings table below for details).

H/C

MULTI

FOSSIL

MASTER

OFF ON

SERVANT ELECTRIC SINGLE HT.PUMP

FIG. 4 Setting the DIP Switch

The following table shows what each switch corresponds to depending on position. Switch one should be set in the “OFF Servant” position unless you plan to broadcast readings from remote temperature sensors to other thermostats in the system when there is no control system in place.

DIP Switch Settings

Application	Switch	Switch	Switch	Switch
	#1	#2	#3	#4
Single Stage Furnace & AC	Servant	Fossil	Single	H/C
Two Stage Furnace & Two Stage AC	Servant	Fossil	Multi	H/C
Roof Top Unit (Two Stage Heat & Two Stage Cool)	Servant	Fossil	Multi	H/C
Boiler with AC (Two Transformers)	Servant	Fossil	Single	H/C
Single Stage Heat Pump	Servant	Electric	Single	HT. Pump
Two Multi-stage Heat Pump	Servant	Electric	Multi	HT. Pump
First Stage Radiant Floor Heat,	Servant	Fossil	Multi	H/C
Second Stage Furnace One Stage of Cooling

Reassembly

No tools required – line up pins on circuit board with the corresponding terminal blocks. Use your hands to push the front panel securely to the mounted base.

ViewStat Communicating Thermostat 9