Chapter 2 : STARTING (continued)

BROAD SCAN (HD/SDI)

2-2. SETTINGS

cWe recommend resetting the BROAD SCAN to all of its default values, with the front panel display menu (CONTROL default value yes) before proceeding.

d Select the auto-setting menu with the front panel display menu (INPUT Auto setting) and activate this function with ENTER. This function detects automatically the input type of the source connected to the input connectors (DVI & RGB). Then the device performs an auto-centering function.

e Select the Input status menu (INPUT Input status) to verify the correct detection of the type and format of your input source. If a wrong message is displayed, select manually the type of your input source (INPUT Input Type).

f Select the output format and rate (OUTPUT Format).

g For SDTV output format (PAL, NTSC) select the type of the RGB/YCrCb output (OUTPUT Type).

2-3. IMAGE ADJUSTMENTS

cSelect the UNDER/OVER scan mode with the front panel button. d Adjust the position & size of the image with the front panel buttons.

e Adjust the level of anti-flicker with the panel display menu (IMAGE Flicker filter).

fPerform the others adjustments, available in the Image menu.

2-4. EMBEDDED AUDIO MODE

The embedded audio menu is available for BHD930 & BSD830 models only. The device allows embedding analog audio stereo signal into the HD/SD-SDI output signals.

cConnect an analog audio stereo source to the AUDIO IN (L /R) connector.

d Activate the Embedded audio mode with the front panel display menu (AUDIO Embed. ON). e Adjust the audio level with the front panel display menu (AUDIO Level).

f Adjust the audio balance with the front panel display menu (AUDIO Balance).

PAGE 16