Analog Devices manual 23

BROAD SCAN (HD/SDI)	Chapter 4 : FRONT PANEL DISPLAY MENU DESCRIPTION (continued)
4-5. FUNCTIONS DESCRIPTION (continued)

[Genlock Tune].

This function is available only if the Output format selected is Genlock, and if a correct genlock signal is detected on the GENLOCK INPUT connector.

[H Phase]: This function allows adjusting the genlock horizontal phase. Adjust with + ENTER.

[SC. Phase]: This function allows adjusting the genlock Subcarrier phase. (Available with Analog SDTV

Genlock signal only). Adjust with + ENTER.

[Type] Available for SDTV output format.

Select the needed signal available on the RGB/YUV output [RGBS]: RGB/S video output.

[RGsB]: RGB with Sync on Green video output.

[YUV]: Component video output.

[Pedestal] Available for NTSC output format. Add a pedestal to the NTSC output format.

[Test pattern]	+ ENTER.
Select one item with

[Grey Scale]: Displays onto the output a grey scale pattern.

[Color bar]: Displays onto the output a color bar pattern.

[Grid]: Displays onto the output a grid pattern.

[SMPTE]: Displays onto the output a SMPTE pattern

[No]: turns OFF the test pattern.

[IMAGE]

[Auto Centering]

This function centers automatically the image source in the screen and then for the RGB signal, performs pixel clock & phase adjustments.

[Optimize]

[Clock]: Manual adjustment of the pixel clock.

[Phase]: Manual adjustment of the pixel phase.

[Aspect in]		+ ENTER.
Select the Aspect Ratio of your input source with
[4/3 standard]: 4/3 input format.
[16/9]: 16/9 input format (computer).
[Aspect out]		+ ENTER.
Select one of the following output aspect ratio with
[Standard]:	The entire image and the aspect ratio are preserved.
[Crop]:	The image is zoomed without deformation to fill the screen, but some borders of the image will
	be cropped. The aspect ratio is preserved.
[Full Screen]: The image is stretched to fill the screen. The aspect ratio is not preserved.
[Zoom]:	The image can be zoomed, cropped and stretched at your convenience.

[Under/over]

Select an item with + ENTER. [Underscan]: The output image is full screen.

[Overscan]: The output is 10% bigger than in underscan mode.

[RGB Levels] (Available for analog input source only).

Select an item with	+ ENTER.
[Red]: Adjust the level of the Red with			+ ENTER.
[Green]: Adjust the level of the Green with			+ ENTER.
[Blue]: Adjust the level of the Blue with			+ ENTER.
[Black Level]		+ ENTER.
Adjust the Black level with

PAGE 23