Maintenance
Electrical Hazard: Before performing maintenance on the cooling unit:
1.Turn the cooling unit off.
2.Unplug the cooling unit.
Warning: Damage to equipment may occur if:
1.Caustic substances are used to clean the cooling unit.
2.The unit is subjected to excess water.
2. Air filters are cleaned too aggressively causing damage.
Clean the exterior
Wipe dirt and dust from the exterior surfaces with a soft, dry cloth. Dampen a cloth with a solution of warm water and mild detergent for heavily soiled areas.
Ensure all detergent is wiped from the surface with a clean, damp cloth to remove residue.
Clean the air filter
Check the air filter frequently after initially putting the cooling unit into service. Determine how long between cleanings you can wait. Keeping your air filter clean will maximize the performance and life of the cooling unit.
1.Remove the air filter. Press down on the two tabs on the top of the grill to release the filter and grill from the cooling unit.
–Pull the air filter from under the small tabs at the edges on the inside of the grill.
2.Clean the air filter. About every two to three weeks clean by gently vacuuming, wiping or knocking the edges of the filter on a firm surface to remove the excess dust.
3.Wash the air filter. To remove excessive soil, soak the air filter in a solution of mild detergent and warm water. Allow to air dry.
Replace the air filter
1.See “Remove the air filter” (above) for instructions to properly remove the air filter.
2.Install a new, clean filter to the grill. Make sure the filter is secured under the tabs along the edges of the grill.
3.Attach the grill to the rear of the cooling unit. Set the bottom of the grill into the opening. Tabs on the grill bottom should enter the slots in the bottom of the opening. Tip the top of the grill up and into the opening. The tabs on the top of the grill should snap into place.
na3358a
InRoom SC 60 Hz User Manual | 19 |
