Introduction
NOTE: Type 2 SPDs are designed for use on the load side of the service entrance Overcurrent Protection Device (OCPD) only.
NOTE: For troubleshooting, call APC Technical Support at
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
•Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E.
•This equipment must only be installed and serviced by qualified electrical personnel.
•Turn off all power supplying this equipment before working on or inside equipment.
•Always use a properly rated voltage sensing device to confirm power is off.
•Replace all devices, doors and covers before turning on power to this equipment.
•This equipment must be effectively grounded per all applicable codes. Use an
Failure to follow these instructions will result in death or serious injury.
Proper installation is imperative to maximize the modular Surge Protective Device’s (SPD’s) effectiveness and performance. The installer should follow the steps outlined in this instruction bulletin to ensure proper installation. Read the entire instruction bulletin before beginning the installation. These instructions are not intended to replace national or local electrical codes. Check all applicable electrical codes to verify compliance. Installation of modular surge suppressors should only be performed by qualified electrical personnel.
Installation and Operation Manual | 7 |