speakers
Connecting speakers
– AVR600 only
� �
������
The AVR600 allows you to connect up to seven speakers
�To connect each of the speakers, unscrew the
Speaker cables
The speakers should be connected to the amplifier using
and three active subwoofers in the main system. The output channels correspond to speakers installed in the
�
corresponding terminals on the back of the AVR600, insert
front left, centre, front right, surround left, surround right, surround back left, surround back right and an active subwoofer.
The configuration and placement of your speakers is very important. All speakers, with the exception of the subwoofer, should be arranged around your normal viewing/listening position. The subwoofer should be placed in a position which gives an even frequency response in all listening positions. Incorrect placement leads to bass boom in some areas. Often the only
way to find a good position for your subwoofer is by experimentation. A good place to start experimenting is close to a wall but at least 1m away from any corners. You can also consult your subwoofer handbook for placement suggestions.
�the speaker wires through
| the hole in each post and | |
| screw the terminals back | |
�� | up. Make sure that the red | |
�� | (positive/+) terminal of the | |
speaker is connected to the | ||
| ||
��� | red (positive/+) terminal on | |
the back panel, and the black | ||
| ||
| ||
��� | speaker is connected to the | |
| black | |
| the back panel. |
It is important that no stray strands of wire from these connections are allowed to
touch another cable or the product casing. Failure to ensure this can cause a short circuit and damage your AVR600.
Do not
false economy and can significantly degrade the sound quality.
The cable runs to the speakers should be as short as practicable. Connections to the speaker terminals should always be finger tight, whether using bare wires or spade connectors.
��� | ��� |
|
� | � |
|
��� | � |
|
��� | ��� | ������ |
�� | �� |
|
��� | ��� |
|
Connecting subwoofers
The AVR600 and the AV888 allow up to three active subwoofers to be connected to the SW1, SW2 or SW3 outputs.
See your subwoofer handbook for the correct setting up and connection for your particular subwoofer.