audio/video connections
Important notes about Component/RGB video inputs and outputs
<When you connect your devices to these connectors, take care to follow the letter/colour coding for each input. No damage will occur but incorrectly coloured or unstable pictures will result.
<The Component video inputs have sufficient bandwidth for NTSC (525/60) or PAL (625/50) video and HDTV video signals.
Before connecting your AVR600 or AV888 and power amplifier (e.g. the Arcam P777) to your source components and speakers, please read through the next few pages which will explain all the input and output connectivity that is available. The ‘Speakers’ section explains how to connect up your speakers to avoid damage to the amplifier and how to arrange your speakers for best performance.
General
The inputs are named to make it easier to reference connected devices (e.g. ‘DVD’ or ‘VCR’). They all have the same input circuit (with the exception of the ‘phono’ input), so there is no reason why you should not connect a different device to any of the inputs. For example, if you had two DVD players and the AV input was not being used, then the second DVD player could be connected to the AV input.
When connecting a video source, its audio must be connected to the corresponding sockets. For example, if you a had a satellite decoder plugged into a SAT video input, the audio must be connected to the SAT audio inputs!
The hierarchy for video connections for best quality is as follows;
<HDMI
<Component/RGB
<
<Composite.
You should connect as many of these as possible. The unit will automatically select the best quality connection for the source available. For any video source to be available in Zone 2 you must have an
Making connections
<Wherever possible, connect both the analogue and digital outputs of digital sources. This enables use of a digital input for the main zone and the corresponding analogue input for recording onto an analogue tape deck, VCR or PVR, or for the Zone 2 or 3 output.
<Take care to place cables as far from any power supply cabling as is practicable, to reduce hum and other noise problems.
����
�� | ��� | ��� | ��� | ��� | ����� | ����� |
HDMI connectors
AV, SAT, DVD, VCR, PVR
Connect the HDMI video outputs of your source equipment to these corresponding HDMI inputs.
OUT 1
Connect this output to the HDMI video input of your main zone display device.
OUT 2
Connect this output to the HDMI video input of your second display device or to another HDMI display device in a second living space. As the unit has only one processed video path, this signal will be a copy of the signal on Out 1.
NOTE
All Zone 1 analogue video outputs will be disabled if an HDMI digital video source is selected.
