Arcam AV888, AVR600 manual Zone 3 connectors, Zone 2 connectors, Digital audio connectors

Zone 3 connectors

��

���

	�	�
	�	�	Z3 OUT
			Connect these analogue audio
��	��	��	outputs to your Zone 3 equipment.
		���
	��	��	See ‘Multi-room Setup’ on page 48
			for information.
	�	�
��� ��		��
		���
	��	��

		��
�	�	�����
		���
		��
		�����
		���
		��
		���
		���	������������
		���
		���
		���

Zone 2 connectors

Z2 AUDIO OUT, Z2 VIDEO OUT

Connect these analogue audio and video outputs to your Zone 2 equipment. See ‘Multi- room Setup’ on page 48 for information.

����

��

��

���

���

���

���

��������������������

Digital audio connectors

TAPE, CD, AV, DVD, SAT, VCR, PVR

Connect these inputs to the digital outputs of your available source equipment.

English

	�	�	Component/RGB
���	��	��	video connectors
		���
	��	��	These inputs are suitable for
		���������������	connection to source devices

AV, DVD, SAT, VCR, PVR

Connect the Component video outputs of your source

���	���
����
������� ���������

S-Video and Composite connectors

�������	���	OPTICAL, COAX
����		Connect the optical or coaxial output
		to your digital recording device such as

which output Component (YUV or YPbPr) or RGB high quality analogue video signals. These

signals are usually available from DVD players, set-top boxes or games consoles.

If you are connecting up to an RGB source you will also need to connect the source’s Composite output to the unit’s Composite input to act as a video sync. The Composite signal should be on the same named input as the RGB signals.

RGB video outputs on source equipment are often on SCART connectors. You will need to use a SCART to ‘RGB+Sync on phono’ breakout cable, available from your Arcam dealer.

NOTE

When setting up the menus (later in this manual), you will need to select whether the three-wire high quality video input is Component or RGB for each input. This is done on the ‘HQ Video In’ line in the Input Config menu. Failure to do this can result in a green looking picture or a picture that is unstable.

equipment to these inputs.

OUT

Connect this output to the Component video input of your display device.

NOTE

Analogue RGB video output is not available from the AVR600 or AV888. The analogue three-wire high quality video output is always configured as Component video.

AV, DVD, SAT, VCR, PVR

Connect these inputs to the S-Video and Composite outputs

of your available source equipment.

VCR OUT, PVR OUT,

These are recording outputs. Connect these to the ‘S-Video in’ or ‘Composite in’ sockets (usually labelled ‘RECORD’) on your recording device.

MAIN OUT

Connect this output to the S-Video or Composite sockets on your primary Zone 1 display.

CD-R, digital VCR or Minidisc player.

When a digital source is selected, the digital output will send an exact

copy of the incoming digital signal. For example, for a

5.1digital source, the digital output will also be in 5.1 format.

When an analogue-only source is selected, this is digitized by the unit and routed to the digital outputs.

These outputs are muted if a source is selected where the HDMI connection is used and is transmitting HD audio. The digital audio from the HDMI link will not be routed to these outputs.

E-9